Top shot from a different angle

Better shot of the rear camber adjustment arm

ECU is ready to be soldered in, dash wires arn't

JB Weld, steel sheet I cut to make the funnel.  Box is upside down

Updates as of 4-17-08, got her outside and washed her

Almost finished product, few screws left and ground wires

Got the dash wires done...

...And the ECU is all soldered up!

Until now, I've had no pictures of my ECU

Hondata interface 4-wire cable and 2Timer switch control

EEPROM exposed in the upper corner

SST 27SF512 EEPROM chip in 2Timer socket on secondary board

My beautiful 28-pin soldering job

Photoshop for the day

New fuel line cover and the rubberized sandblasting box

Fuel line cover installed with new hardware

An underside shot of the passenger rear

Next-->

| 0 | 1 | 2 | 3 | 4 | 5